Newton Roof Pros provides professional flat & low-slope roofing in Newton, MA for residential and commercial properties across Middlesex County and the inner-western suburbs. Almost every Newton house has low slope somewhere even if the front elevation is a steep gable. Rear ells, third-floor decks, porch roofs, bay caps and the shed dormers added in the 1950s all sit under 2:12, and that is where most of our leak calls originate.
Shingles do not belong there and a surprising number of these planes have them. A laminate shingle at 1:12 relies on gravity that is not present, and the water sits at the butt edge until it finds a nail. When we pull one of these apart the deck underneath is almost always black. Replacing shingle with membrane on those planes is often the single highest-value thing you can do to an old Newton roof.
For product we run 60-mil EPDM fully adhered on most residential low slope, and TPO where the plane is visible from a window and the owner wants white. Adhered rather than ballasted, because ballast on a third-floor deck over occupied space is a load nobody calculated. Seams are tape and primer, corners are pre-formed, and terminations get a bar and sealant rather than a bead of caulk and optimism.
Drainage is the design decision that gets skipped. These planes usually drain to a single scupper or a gutter that was sized for a much smaller roof, and after a February thaw the whole plane is a pond with an ice lid. Where the framing allows it we build tapered polyisocyanurate to move water to two outlets rather than one, and where it does not, we say so and specify an overflow.
License scope on low slope is the same as anywhere else. Membrane over a sound deck is roof covering. A deck that has been ponding for fifteen years is usually not sound, and once the rot passes a quarter of the plane the job is beyond a specialty roof covering license and needs an unrestricted supervisor on the permit. We probe before we quote so that number is in the original estimate.
Where a low-slope plane meets a wall, which on a Newton ell is always, the membrane turns up at least eight inches and gets counterflashed into the siding or reglet-cut into the brick. A membrane terminated under a clapboard with a bead of sealant and nothing else is the defect we find most often on other people's low slope here.
Our licensed and insured team brings the right materials and equipment to every job — 1x6 plank sheathing with open board gaps, half-inch CDX re-sheathing overlay, ice barrier carried two feet inside the warm wall, unfading Vermont slate on copper slate hooks, 16-ounce copper open valleys, lead-wedged counterflashing in soft lime mortar — and backs the work with a written workmanship warranty. We serve Newton and nearby communities including Waltham, Watertown, Brookline, Needham.
What We Handle
Everything our flat & low-slope roofing in Newton covers
One crew, one point of contact, and the full range of flat & low-slope roofing work in Newton, MA. If it is on this list we do it in house rather than handing it to a subcontractor:
- flat roofing newton
- flat and low slope roofing
- epdm roof newton ma
- tpo roofing newton
- low slope porch roof newton
- rubber roof rear ell
- tapered insulation newton ma
- flat roof deck replacement
- membrane roof newton massachusetts
- third floor deck roofing
Not sure which one describes your situation? Describe it in plain words and we will sort it out — or browse the rest of our Newton services.
Materials, equipment and how we do flat & low-slope roofing
The difference between flat & low-slope roofing that lasts and flat & low-slope roofing that gets redone in three years is almost always preparation and materials, not the finish you see on day one. We work with 1x6 plank sheathing with open board gaps, half-inch CDX re-sheathing overlay, ice barrier carried two feet inside the warm wall, unfading Vermont slate on copper slate hooks, spec them to the job instead of to the invoice, and write the material grades into the free estimate so you know exactly what you are buying.
Every Newton job runs the same way: site walk and measurements, written scope and fixed price, protection of the surrounding area, then the work itself with a daily clean-up. Years of roofing work in Middlesex County and the inner-western suburbs means we have already met whatever your property is going to throw at us — awkward access, older construction, an HOA with opinions.
Where we do flat & low-slope roofing outside Newton
Newton Roof Pros covers Newton and the surrounding communities of Middlesex County and the inner-western suburbs. Crews run out to the same nearby cities every week, so an out-of-town job does not mean an out-of-town price.
- Flat & Low-Slope Roofing in Waltham, MA — Middlesex County, population 65,218
- Flat & Low-Slope Roofing in Watertown, MA — Middlesex County, population 35,329
- Flat & Low-Slope Roofing in Brookline, MA — Norfolk County, population 63,191
- Flat & Low-Slope Roofing in Needham, MA — Norfolk County, population 32,091
- Flat & Low-Slope Roofing in Wellesley, MA — Norfolk County, population 29,550
- Flat & Low-Slope Roofing in Weston, MA — Middlesex County, population 11,851
Start on the Newton Roof Pros homepage for a free estimate, or call (844) 511-2320 and describe the job.
Why Newton Chooses Newton Roof Pros
- ✓We check the deck before quoting, because a roof covering license covers only a quarter of the sheathing and Newton's pre-1930 stock regularly exceeds it.
- ✓Every estimate is already a Chapter 142A contract: materials, dates, capped deposit and cancellation rights on the same page you sign.
- ✓We file the building permit under our own license, which is what keeps your Guaranty Fund eligibility intact if anything ever goes wrong.
- ✓Photographs by roof plane, layer counts at the rake, and deck probes at eaves and valleys, given to you whether or not you hire us.
The standards behind flat & low-slope roofing
Quality here is not a matter of opinion — it is written down. The flat & low-slope roofing work we do in Newton follows published industry standards: NRCA publishes the Roofing Manual, the industry's reference for details and slope minimums, and Asphalt Roofing Manufacturers Association sets the shingle application and ventilation guidance the warranties reference. If a contractor cannot tell you which standard a detail comes from, that is worth asking about before you sign.
Every flat & low-slope roofing project in Newton gets the same attention, whether it is a single room or a full commercial job. We show up on schedule, keep the site clean, and stand behind the work — the estimate is free and there is no pressure.
Ready to get started? Call (844) 511-2320 for a free flat & low-slope roofing free estimate in Newton, or request a quote and we'll get right back to you.